The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Photos of the "bad mast!"

2022-06-19; 20:17:17 EDT

Member Since

2002-08-01

Posts: 1438

Tony,

I hate to be the bearer of bad news.  As I look at the damage, it looks like it spans at least 25% of the circumference of the mast.  Even worse, the two holes are right across from each other. Aluminum alloys have to be specially heat treated in order to be both strong and fatigue resistant.  The welding process will destroy the heat treatment in the heat affected area.  Even if you welded a patch all the way around the mast big enough to cover the damage, the weld bead will create a weak, soft spot in the mast above and below the patch.  The only solution would be to run the whole mast thru heat treatment after the patch was welded on.  That would require a furnace big enough to fit the whole mast and all the fittings would have to be removed first and then reattached.  At the end of the day, it all comes down to cost.  I suspect it will be cheaper to replace the mast vs repair it.

Roger Pihlaja
S/V Dynamic Equilibrium

Sent from my iPhone

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting