The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

C. Robert Lester



Swing keel stuck.

2022-06-28; 19:18:50 EDT

Member Since

2010-12-23

Posts: 98

Thanks Ric!

I should add that the CB is stuck because I didn't raise the penant line when the trailer roller, tucked the CB into the keel when taking the boat out of the water last season.
The penant line is sandwiched I feel in between the keel & CB.

The CB on my boat is the old style and the same shape as the rudder.

It is nice to hear someone else "dives" under to fix the issue.

Bob
'84 ORION

From: ric at stottarchitecture.com
Sent: June 28, 2022 2:38 PM
To: rhodes22-list at rhodes22.org
Reply-to: rhodes22-list at rhodes22.org
Subject: Re: [Rhodes22-list] Swing keel stuck.

I moor my boat in shallow water.
During normal low tide the keel is off the bottom by a few inches. When the tide is below normal, sometimes the keel rests on the sandy/small stone bottom.
Sometimes this results in a small stone getting wedged between the CB and the trunk.
The only way to clear it is to dive under the boat.  I have a long shank screw driver that I use to scrape the stone out.
I imagine marine growth could do the same thing and be remedied the  same way. If your CB pendant is loose, be sure to be out of the way when the CB swings down.
I often set the pedant to about half way, then make the dive. For the old style  center board ( don’t know which you have) the small turning blocks could be bent or jammed also.
The blocks are only available in the UK.
Good Luck!
Ric
Dadventure

Richard F. Stott, AIA, LEED AP
ric at stottarchitecture.com
O -631-283-1777
C- 516-965-3164



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting