The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Ric Stott



Tongue-shaped flap in centerboard trunk gasket?

2022-07-05; 12:08:22 EDT

Member Since

2013-07-01

Posts: 436

BTW
I have mentioned that the tubes help to reduce CB ‘Clunking’. Imagine the CB resting on its pivot tube in the tapered slots of the CB Trunk. Without those two hoses, the CB  can rock side to side on the pivot pin - one side lifting, then the other.
The hoses keep the pivot pin from rising in the slot and allowing the CB to move (as much) side to side.
So the  two hoses fill the gap between the Pivot pin and the cap keep the CB from rocking side to side as well as sliding up in the tapered slots.
Sail-on
Ric

Richard F. Stott, AIA, LEED AP
ric at stottarchitecture.com
O -631-283-1777
C- 516-965-3164



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting