The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Chris Geankoplis



The mast has been welded...

2022-08-06; 12:34:41 EDT

Member Since

2004-04-05

Posts: 2060

There is an important piece of hardware between the two spreaders.  Inside the mast, there is a thick aluminum ferrule that prevents the long single bolt that joins the two spreaders together, from compressing the mast if it is over-tightened or the vectored forces of the rig compress the walls of the mast at this point.  Well I assume that is its function.  This is the case for my '83 mast,  Though as I write this is it possible I am thinking of my 1976 mast.  Damn!  I Think I'm getting old.  Can someone confirm or debunk this memory? Not sure if this can be retro-fitted at this juncture or how critical it really is, especially with the extra plates welded on. Be sure to use an galvanic isolation compound anywhere SS is in contact with Aluminum.  I think you made the right decision to fix the mast the way you did, now you can begin enjoying the joy of sailing a Rhodes.

Chris Genakoplis
Zenos

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting