Bob,
In my opinion your best bet will be to find a plastic fabrication company with experience working with marine grade Starboard (or similar) to recreate this piece - unless you can do it yourself. Last year I had to replace the side panels in that rudder head assembly - after spending too much time exploring other alternatives I ultimately had them made at Precision Plastics in Beltsville MD, which isn’t too far from you. They did a great job, based off the old panels; the job took them about a week.
Hope that helps
Jose
> On Sep 27, 2022, at 4:33 PM, Peter Nyberg <peter at sunnybeeches.com> wrote:
>> Bob,
>> The whole rudder assembly is designed and custom built by General Boats, so that's the only place you're going to be able to buy a replacement part. If GB is unable to supply a replacement, then I think your only option would be to make your own.
>> --Peter
>>> On 2022-09-27, at 12:47:43 EDT, Bob Garrant wrote:
>>>> The sheave (?) to used to pull down the rudder has broken. Anyone know where I
>> can find a replacement for this.
>>>> I’m not sure whether sheave is the correct term.
>> It’s at the base of the fixed part of the rudder and it’s used to pull down the
>> rudder. The blue line raises the rudder to a 90° angle out of the water. The red
>> line pulls it down.
>>>> See attached pictures.
>> Thanks,
>> Bob Garrant
>> Sail la Vie, 2000/2017
>> Kent Island, MD
>>>> <a
>> href="http://rhodes22.org/pipermail/rhodes22-list/attachments/20220927/1b43f6b9/attachment.jpe"
>> target="_blank">image_67144449.JPG</a>
>>>> <a
>> href="http://rhodes22.org/pipermail/rhodes22-list/attachments/20220927/1b43f6b9/attachment-0001.jpe"
>> target="_blank">image_67181825.JPG</a>
>>>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.