The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Stephen Staum



Roller furling part

2022-10-24; 14:37:07 EDT

Member Since

2004-05-24

Posts: 586

Frank,

I had the same problem a few years ago on the Carol Lee 2.  The piece fell off while we were sailing and it was hard to roll the genoa.  Since the boat was on the mooring midseason I needed a quick easy fix.  After removing the remaining 1/2 plate I bought a cap for 1/2" PVC pipe (available at any good hardware store).  I drilled a hole in the middle of the cap approximately 1/8" wide to accommodate the forestay.  I cut the cap in half so I could place it over the forestay with the genoa assembly lifted up a few inches.  I also sliced a 4" piece of 3/8" ID nylobraid (reinforced flexible pvc tubing - also available in a good hardware store) and slid it over the forestay above the cap.  The split cap was then secured with a stainless steel hose clamp (available guess where?)  The nylobraid was slid into the cap and into the furler pipe acting as a pivot point and centering bearing.  All the materials cost less than $5 and it worked so well that I kept it that way and sold the boat years later with a spare split cap on board to use when the old one wears out.  The cap rests on the top of the forestay crimped fitting and the whole assembly pivots on it.  Call me if you need a better explanation of this easy fix.  Email directly for my number.

* Thanks and Stay Well,*

*Stephen Staum*
*s/v Pinafore*

*Needham, MA*



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting