The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Reuben Mezrich



Rub rail problem

2022-10-29; 16:23:31 EDT

Member Since

2020-01-16

Posts: 133

During Hurricane Ian all the water In our little harbor in Sarasota ran out as the storm approached and then returned as the storm passed, but we had no real surge. As the boat made its journey down to the mud and then back up again it appears the rub rail (or at least the red part that stands proud of the bulk of the rub rail caught on a fender and popped out of it’s fitting. When I got back to the boat only a few feet at the bow and the stern on the starboard side was still attached.
Following the instructions on the Taco website (Taco makes the rub rail that Stan uses) I managed to get most of it attached, except about 3 inches in the middle. The rest of the rub rail, all the way around the boat is attached nicely and there is no slippage. I assume the rubber stretched
So what to do?  Would heat help or hurt?  I suppose I could cut off a bit, but I think that’s a last resort
Any thoughts?
Reuben


IMG_1904.jpg
Reuben Mezrich
Cell:410-499-8922
Pelican Cove in Sarasota and Back Bay in Boston
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting