Lee,
As long as you push on the ball check valve with something soft, like a piece of plastic, you are unlikely to damage it. I always drain the gas line at the end of the season.
Roger Pihlaja
S/V Dynamic Equilibrium
Sent from my iPhone
> On Nov 30, 2022, at 5:11 PM, Lee Kuhn <lvjkuhn at gmail.com> wrote:
>> What's the easiest way to remove gas from the fuel hose? The hose has a
> ball spring valve at both ends. I was told not to push the valve open with
> some type of tool because I could damage the valve.
>> I disconnected the tank and put it in the lazarette and then reran the hose
> into the lazarette and reconnected the hose to the tank which opened the
> valve on that end. I then disconnected the hose from the outboard and
> held it up as high as I could (gravity) and squeezed the primer. The
> primer pumps gas in the opposite direction than I wanted but if you squeeze
> it hard and slow the gas will eventually drain into the tank.
>> Seems like there must be a better way. The gas was ethanol-free with a
> stabilizer. Should I just leave it in the hose and hope I won't have any
> problems starting the outboard in the Spring?
>> Lee
> 1999 Rhodes22 AT EASE
> Claytor Lake, VA
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.