The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Todd Tavares



IMF Mast and Sail

2023-01-01; 14:54:08 EST

Member Since

2002-09-10

Posts: 976

Ric,

You seem to express some reservations.

Will the benefits of the IMF justify the change, the work, and associated costs?? In my opinion, if you keep your boat in a slip or on a mooring ball, I say go for it. But if you keep it on a trailer and have to raise the mast and rig up every time, it might not be much more of a convenience (I actually enjoy the rigging up and raising sail part). But the ease of stepping onto the boat in a slip and just casting right off would be sweet.

If you've already planned on spending a few hundred dollars extra, you might as well just replace the standing rigging too.

I don't now if the mast lengths are the same for the IMF and standard masts; or if the spreaders are the same length. Maybe someone could provide the length of the mast, pin to pin measurements for the shrouds and stays and the length of the spreaders? If the mast lengths are the same and the spreader lengths are the same, I'm sure the shrouds and stays would be close.

You would have to check the base fitting too. It appears the IMF may be wider than the 4"x3" standard mast extrusion.
You'd also have to fabricate the boom attachment gooseneck car assembly. But there are plenty enough pictures on the site to make your own. If it were me, I'd have a few shroud extenders on hand, run the turn buckles all the way out and raise the mast using the standard rigging-- and go from there.

Todd T





See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting