2023-02-18; 21:41:27 EST
Member Since
2002-09-10
Posts: 976
Peter, Can you give us a little information first so we can give you more help and better advice? 1.) Where will the boat be located when you take possession? Maybe someone will be close enough to help with the mast raising. And if you are handy, I can give you enough info and pics to build your own system. I use the trailer winch. You may not know these answers yet. 2) What type of foresail furler do you have? 3) What type of mast do you have? 4) What type of traveler do you have? Ok... As the other Peter said, both spreaders should be the same length. You could cut the longer one down to match or make 2 new ones depending. I have 2 sets. One on my 1984 and a set from an older 1976 in the garage. Both standard masts (not IMF). The ones on the 1984 are 35½" (measured 35 5/8ths when measured from the side of the mast to tip when sitting in the bracket) and the ones from the 1976 are 35" measured directly. So the 35½ is probably the better length for your 1986 if its a standard mast. In that range should work as long as they are both the same. We'll help you sort out the arrangement of the shrouds and stays when you're ready. I'll give a brief description now and you can refer back to it when the time comes. I have the standard mast so this applies to my set-up. The spreader brackets should be triangular on the bottom. The lower shrouds (shortest ones- 4 each) attach to the two holes under the spreaders and go to the chain plates on the cabin top. Forward and rear goes without saying. The upper shrouds are attached to a tang on either side of the mast, just below the mast head fitting. They run through the spreader tips and to the chainplate tangs coming out of the toe rail on the sides of the deck amidships. Your masthead fitting may be different than mine, but the forestay attaches to the front of the fitting. My forestay has swaged T bolt and toggle fitting swaged at the top. That connects to another toggle that rides over a pin going through both sides of the masthead. The bottom attaches to the chainplate tang on the bow. The backstay is a continous wire that has a swaged fitting creating an inverted V with a loop at the top. It attaches to the masthead fitting by a single toggle over a pin through the masthead fitting. The bottom ends attach to the chainplates on the stern corners. Todd T backstay.jpg Tang and forestay1.jpgSee the original archive post