The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

peter beckerman



Pop top support

2023-04-13; 08:28:39 EDT

Member Since

2023-01-29

Posts: 157

Hi All,
   Quick question.  Yesterday was my 1st opportunity to spend a few hours on my boat running down some projects.   The supports for the pop top are not in place and therefore are in the way.  Looking at how they're supposed to attach it looks as though there should be some plastic washer-like fitting that the tube fits through that is bolted to the top and that prevents the tube from coming out of place, or falling into the cabin when there is no load.  You can see in the attached image that mine are broken.  Is there a ready source for these parts, or should I warm up my 3d printer (greatest boat tool ever!).  It appears to me that these washers don't carry much load (and can therefore be printed)  is that correct?  I've never seen this pop top in action,  so I'm not quite sure how it all works.

Thanks,
   Peter

20230412_180243.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting