The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

peter beckerman



Pop top support

2023-04-24; 11:34:44 EDT

Member Since

2023-01-29

Posts: 157

 Hi All,
Just following up. I went ahead and printed some bushings for my pop top. I suspect that Roger is correct and ABS plastic is not the best material for the job, but I'm tight for time and would like to get in the water in a few weeks and this solution will last until I get a chance to fabricate a better one sometime this summer. I've included a couple of pictures for those who are curious. As always, thanks for the help.

Peter     On Thursday, April 13, 2023, 09:20:08 PM EDT, Chris Geankoplis <chrisgeankoplis at gmail.com> wrote:

 I’ve made those “doughnuts “ several times over the years, maybe 3 or 4 times for various Rhodes and even an Ensenada. Starboard, (well a Walmart cutting board) a Harbor Freight holesaw kit and table saw or jigsaw. Bob’ your uncle.  That being said, 3-D printing is just too cool to pass up. Let us know how it goes, be sure to post pictures of the process.Chris GeankoplisXENOS

20230422_134130.jpg

20230423_150108.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting