2023-06-07; 17:13:53 EDT
Member Since
2016-04-14
Posts: 711
Peter, Instead of hijacking a thread, you could create a new one by changing the subject line. On my boat, there are two holes in the forward edge of the rudder blade (see pic #1). Lines with stopper knots are fed through these holes in opposite directions. These lines then go into a channel at the forward edge of the upper part of the rudder, and come out below the tiller (see pic #2). Then the lines go into a vice-like device that's tightened with a star-knob. What I've described as two lines is really one line that loops over the tiller, and then back down. There are lots of variations as to clamping/cleating hardware, but that's the basic routing. Peter Nyberg Coventry, CT s/v Silverheels (1988/2016) Rudder Downhaul #1.jpeg Rudder Downhaul #2.jpegSee the original archive post