The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

peter beckerman



Triad trailer manufacturers plate

2023-08-22; 21:48:05 EDT

Member Since

2023-01-29

Posts: 157

That's about where I'm at, first in PA you need an official (police officer etc) to certify that the plate is
not readable, then a weight certification which may have to be completed by a mechanic (not sure about that one) then a form (and a check) to the state DMV. The part I'm not sure about is Gross weight and capacity which I think will be used to determine whether I need to have brakes installed. I plan to
Install brakes anyway, I'd just prefer to have the trailer registered first rather then spend the money, only to find out there's some other (possibly insurmountable) bureaucratic hurdle to overcome. If anyone has that info, I'd prefer to be forewarned.

Thanks,
 Peter     On Tuesday, August 22, 2023 at 04:04:17 PM EDT, Ric Stott <ric at stottarchitecture.com> wrote:

 I bought a Triad Trailer from  fellow Rhodie On LI once about 8 years ago - it was a project trailer and had no title.  I fixed it and made it usable, new wheels, axel, extension bar, etc -  and used it to launch  at the beginning of the season and retrieve in the fall. Last Fall I had to leave it at the ramp while I brought the boat to its mooring and I got a traffic ticket for an unregistered trailer. The DMV told me I could take it to a local weigh station and get a weight certificate - them bring that to the DMV to register it. I have yet to do that, but I will. Ric SV Dadventure HBNY

Richard F. Stott, AIA, LEED AP
ric at stottarchitecture.com
O -631-283-1777
C- 516-965-3164



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting