2023-08-31; 14:25:33 EDT
Member Since
2022-05-18
Posts: 26
Rhodies, I recently liberated my mast step tabernacle from the deck while (not) raising the mast. At first I was perplexed that the machine screws pulled right out. After further review I've learned that this is by design. I've reviewed the post that I could find related to the repair, and called West Systems for their take. I'm still left wondering which way to go. I'm wondering if anyone has anything to add. I was going to fill the cleaned and chamfered holes with thickened epoxy (System 105/205), with no toothpicks or wood shavings. Then drill and tap the semi-cured epoxy for the 1"-20 machine screws. The questions I had regarding this method were: 1) Why do I need wood shavings or toothpicks? I don't plan to take the screws out for any reason. 2) If I let the epoxy set up (but not cure) would I be able to drill and tap it? 3) How long would I let it set up before drilling? It seems form my research that drilling and tapping fully-cured epoxy is very difficult. 4) If using the epoxy with shavings or toothpicks what is the order and timing of the re-assembly? After talking to West Systems, I think I'm leaning towards what they said to do: 1) Clean out any old material 2) Oversize the holes to make room for the epoxy between the machine screws and the existing deck 3) Chamfer the top of the holes at the deck 4) Wet out the holes and screws with un-thickened epoxy 5) Thicken the epoxy with 406 or 410 6) Fill the holes with thickened epoxy 7) Set the tabernacle plate and insert the 1"-20 machine screws 8) Clean off the excess epoxy that is displaced from inserting the screws 9) Tape the screw heads down to prevent the screws lifting from hydraulic pressure. 10) Let it cure and go sailing With the solid (non-cored) deck, there should be no need to use any butyl or sealant. Looking for any other advice or opinions anyone may have on the topic. David Berg Blue Loon, Rhodes 22 1996/2003 MinneapolisSee the original archive post