< prior
Back to Month
Go to Thread
2023-11-01; 15:12:51 EDT
Member Since
2019-09-28
Posts: 84
I just discovered after washing my boat that I have a slight leak at the upper shroud chainplate. I took off the interior trim and saw the same tang (t-shap) that Todd showed. Has anyone rebedded the topside piece? I don't really want to unscrew the two bolts/screws in the toe rail and find that I can't put them back. [image: Shroud attachment.jpg] Shroud attachment.jpgSee the original archive post
On Wed, Nov 1, 2023 at 12:09 PM ROGER PIHLAJA <roger_pihlaja at msn.com> wrote: > So Rick, > > Assuming your chainplates were constructed like Todd’s boat, when your > chainplate pulled out, how did it fail? Did the thru bolt fail or did the > tang fail? > > Roger Pihlaja > S/V Dynamic Equilibrium > > Sent from my iPhone > > > On Oct 31, 2023, at 7:30 PM, Todd Tavares <tavares0947 at gmail.com> wrote: > > > > Roger, Rick, All, > > > > I can not remember much about the upper shroud chainplates which run up > > through the toe rail; or how the deck to hull joint is constructed for > that > > matter, but here are a few pictures I took from my old 1976 model Rhodes > > 22. The previous owner cut a section of the cabin liner out with a > series > > of drilled holes. The chainplate consisted of two tangs, crossed and > bolted > > together. I never investigated them any more than making sure the nuts > were > > tight. But looking back at the pictures now, I can't figure out where the > > heads of the bolts were, but guess they were behind the rub rail. (?) I > > have never taken the rub rail off any of the three Rhodes 22s I've owned. > > > > Todd T > > > > > > > >> On Fri, Oct 27, 2023 at 6:38 PM ROGER PIHLAJA <roger_pihlaja at msn.com> > wrote: > >> > >> Rick, > >> > >> Tell us more about how one of the upper side stay chainplates failed > >> suddenly and without warning. I agree it’s hard to inspect the way it’s > >> glassed in. However, if the FRP substrate failed, I would expect it > would > >> get “mushy” first. Similarly, if the stainless steel chainplate itself > >> failed, I would expect it to gradually get weaker as the pitting and > cracks > >> extended. Either mechanism would cause a situation wherein you would > have > >> issues with maintaining the shroud tension. After every sail, the > shroud > >> would be loose. Since you claim the failure happened suddenly without > >> warning, please tell us what happened. > >> > >> Roger Pihlaja > >> S/V Dynamic Equilibrium > >> Sent from my iPhone > >> > >>> On Oct 27, 2023, at 4:44 PM, ROGER PIHLAJA <Roger_Pihlaja at msn.com> > >> wrote: > >>> > >>> Rick, > >>> > >>> What yelling? You start the engine. While it’s warming up, you walk > to > >> the bow, and snag the anchor rode downstream of the carabiner with a > boat > >> hook. You motor slowly forward while pulling in the anchor rode hand > over > >> hand over the railing. Note that you haven’t touched the bow cleat or > the > >> carabiner. When the anchor is aboard, you go and redeploy. No muss, no > >> fuss. I am just claiming that my technique makes it less likely the > anchor > >> is going to drag. Often, your suggested options of going someplace > else or > >> going to shore are not available. The Rhodes 22 has the advantage of > >> shallow draft and can often be anchored in a corner of the harbor where > the > >> big boats can’t go. We all have a vision of being alone in a pristine > >> anchorage. But, that’s often not the reality. Have you actually done > much > >> anchoring out? What do you propose to do if you’re not willing to > anchor > >> in close quarters? Remember, there are no slips available and it’s too > >> late to go somewhere else. > >>> > >>> Roger Pihlaja > >>> S/V Dynamic Equilibrium > >>> Sent from my iPhone > >>> > >>>> On Oct 27, 2023, at 4:19 PM, Rick Lange <sloopblueheron at gmail.com> > >> wrote: > >>>> > >>>> Roger, > >>>> > >>>> If you wake up dragging, it is likely you will need to quickly > redeploy. > >>>> That's not easily and safely done in the dark with your anchor tackle > >>>> complications. And any "optimizing" that ignores emergencies just > >> leads to > >>>> a short life--and a lot of yelling. > >>>> > >>>> I am not suggesting an all chain rode. I am saying you need a 20' > chain > >>>> between anchor and rope rode, as you have. The rope should be no less > >> than > >>>> 7 times longer than the water depth. If you can't find a spot that > has > >>>> enough room, go to shore or to another anchorage. Good seamanship is > >> not > >>>> squeezing in. > >>>> > >>>> One of the few faults with the R22 is that the chain plates cannot be > >>>> visually inspected. Some on this list have opened inspection holes in > >> the > >>>> cabin inside walls to make inspection possible. The lower stays did > >> their > >>>> backup job fine, however, reattaching the plate and repairing the hull > >> was > >>>> expensive. > >>>> > >>>> I ran out of gas trying to beat a storm that was not predicted. The > >> lesson > >>>> learned was to always carry a full reserve tank on the open lake. > >>>> > >>>> Regards, > >>>> > >>>> Rick Lange > >>>> > >>>> > >>>>>> On Fri, Oct 27, 2023 at 1:29 PM ROGER PIHLAJA < > roger_pihlaja at msn.com> > >> wrote: > >>>>> > >>>>> Rick, > >>>>> > >>>>> For those of us that actually stay overnight at anchor, there are two > >>>>> major issues we worry about: > >>>>> 1: Is my anchor going to drag? > >>>>> 2: If the wind or current shifts, is my swing circle going to > interfere > >>>>> with the boats anchored around me? > >>>>> > >>>>> With a given anchor type and anchor rode configuration, the best way > to > >>>>> reduce the chance of dragging anchor is to increase the scope ratio. > >> With > >>>>> a small boat, like a Rhodes 22, an all chain anchor rode is simply > too > >>>>> heavy to be a practical option. I use a boat length of chain > >> connected to > >>>>> 150 ft of 3/8 inch diameter three strand nylon rode. > >>>>> > >>>>> The best way to assure your swing circle isn’t going to interfere > with > >>>>> other boats is to make your swing radius as small as possible, with > an > >>>>> acceptable scope ratio. Why would I want to make my swing radius > >> bigger? > >>>>> The reality of small sailboat cruising is that we tend to arrive at > an > >>>>> anchorage late in the day. By this time, the power boats have > already > >>>>> dropped their hooks for the evening. We often have to find a place > >> among > >>>>> the boats that are already in place and the newcomer always has to > >> yield > >>>>> right of way. Having a small swing radius lets us squeeze in where > >> most > >>>>> boats could not. > >>>>> > >>>>> My suggested anchoring technique enables one or the other of these > >> issues > >>>>> to be optimized. All other anchoring scenarios put together make up > a > >> very > >>>>> small % of the total use of your anchor. I’m glad you were able to > >> keep > >>>>> your boat off the rocks by emergency anchoring. But, this scenario > has > >>>>> very little to do with normal cruising. Good seamanship would > dictate > >> that > >>>>> you inspect your rigging and pay attention to your fuel level so you > >> don’t > >>>>> have to emergency anchor. But, those are entirely separate issues. > >>>>> > >>>>> Roger Pihlaja > >>>>> S/V Dynamic Equilibrium > >>>>> > >>>>> Sent from my iPhone > >>>>> > >>>>> > >> > > -------------- next part -------------- > > A non-text attachment was scrubbed... > > Name: Shroud 1.JPG > > Type: image/jpeg > > Size: 114309 bytes > > Desc: not available > > URL: < > http://rhodes22.org/pipermail/rhodes22-list/attachments/20231031/311ea9ae/attachment.jpe > > > > -------------- next part -------------- > > A non-text attachment was scrubbed... > > Name: Shroud 2.JPG > > Type: image/jpeg > > Size: 118074 bytes > > Desc: not available > > URL: < > http://rhodes22.org/pipermail/rhodes22-list/attachments/20231031/311ea9ae/attachment-0001.jpe > > >
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 