On Tue, Nov 7, 2023, 4:28 PM Peter Nyberg <peter at sunnybeeches.com> wrote:
> Cary,
>> I've done this, but I always just eyeball it by holding the drill bit next
> to the screw. If you're going to use a reference table, I'd use the size
> suggested for hardwood.
>> --Peter
>> > On 2023-11-07, at 13:57:25 EST, Cary Tolbert wrote:
> >
> > This seems like a good thread to tie into, Tabernacle pulled out of the
> mast
> > step. Filled with epoxy and silica. My question is: what size hole do I
> drill
> > for a # 12 SS sheet metal Screw? I have found info on hardwood, soft
> wood,
> > sheet metal but I can't find anything for epoxy drilling. Thanks guys.
> I know
> > someone on the list has experience in this matter.
> >
> > Cary
> > S/V Whisper 86
> >
> >
>>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.