The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

peter beckerman



Mast Base Repairs: was Delaminating tiller handle

2023-11-08; 21:05:18 EST

Member Since

2023-01-29

Posts: 157

 Hi Todd,   Thanks for the response.  I had a screw pull out due to a mast raising mistake (1st time raising ie. a learning experience ....I've been having a bunch of learning experiences since I bought this boat).  I was under the impression that, more or less, the fix for a pulled screw was to drill out the threads and fill with thickened epoxy.  Some then tap threads (hard), some drill a pilot hole and use a wood screw (easier...and the approach I've been tentatively planning on pursuing), and I gather that some set the screw before the epoxy hardens, essentially glueing the screw in place.   My (limited) understanding is using the epoxy-drill-wood screw method allows the screw to pull out in case the mast levers the tabernacle.  I suppose I could alternatively epoxy a wood plug in a drilled hole and screw into that.  I know this has been discussed on the list before, at some point I'll search previous postings.
Peter
    On Wednesday, November 8, 2023 at 07:20:51 AM EST, Todd Tavares <tavares0947 at gmail.com> wrote:

 Peter,
I have not read all of the responses to your mast base bracket questions. Did the screws pull out because of water intrusion and rotted core? Or was it the result of a mast lowering mistake which lifted the bracket and pulled the screws out?The screws pulling out is the desired fail point, which keeps a mistake, like forgetting to disconnect the pop top from the mast before lowering, from ripping the top of the cabin off.
But in either case, the screws should not be screwed into anything other than the plywood core of the cabin top raised pad, if that's what you are calling the tabernacle.If a mistake while lowering the mast levered the screws out; and it were me on my boat,  I'd fill the old holes with sealer or some thinkened epoxy and drill new holes in the bracket to move the screws. If the core was wet and/or rotted I'd replace the failed core and fix it by normal (West System) methods and put the screws back in the original holes going into only the wood, and sealed.If you make a permanent epoxy repair, or heaven forbid, through bolted the base bracket, next time the damage would or could be more extensive.
Todd T.
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting