The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Mast Base Repairs: was Delaminating tiller handle

2023-11-09; 13:44:44 EST

Member Since

2002-08-01

Posts: 1438

Hi Peter,

Others have given good advice re how to repair the mast tabernacle base.  If the wood under the mast tabernacle base is rotten; then, that must be repaired first.  The acetone diluted/slow cure epoxy I disclosed previously can be a part of that repair; but, there is more to such a repair.  I suggest you check the list archives for more details.  If all that happened is the wood screws pulled out; but, the wood is still sound; then, I would drill out the blown out holes until you get to sound wood.  Then, wet out the sides and bottom of the holes with unthickened epoxy.  After the epoxy kicks; but, before it fully cures, fill in the holes with thickened epoxy.  I like to use West System 406 colloidal silica thickening agent.  Mix the resin and hardener together first and get them well mixed.  Then add the thickening agent until you get a paste like consistency that can be forced into the holes with a putty knife.  The uncured, unthickened epoxy on the sides and bottom of the holes will bond with the thickened epoxy to give a solidly attached plug.

Mast stepping/unstepping is one of the most potentially hazardous operations we do.  (Holy Captain Obvious!)  If your boat didn't come with a manual, I suggest you sit down, write a checklist of the steps involved, and follow your procedure scrupulously.  I would also strongly consider getting the GBI mast stepping system.  It's an expensive option and adds several rigging/unrigging steps to an already lengthy process.  But, it makes an otherwise hazardous process MUCH safer.  The nice thing about the GBI system is that if something goes crooked when the mast is partially up or down, you can safely stop, attend to the issue, and then resume the process.  I've been using the system for years.  It's well worth the money, especially if your boat has the Inner mast furling option, which makes the mast even heavier vs the standard mast.

Roger Pihlaja
S/V Dynamic Equilibrium
1978
Sanford, MI

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting