The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Inner Shroud Issues

2023-11-09; 21:30:25 EST

Member Since

2005-04-29

Posts: 814

I had to replace the inner chain plates on my 76 R22 - or at least I thought I had to. Mine were loose and that worried me. As the chainplate was just a stainless steel tang that went through the deck I really could not tell what was holding it or how it might be secured. So I went in from the deck side with a grinter and removed everything down to the cabin liner. After grinding out the deck and core I realized that the chainplate was only attached to the underside core of the deck with a single 1/2" screw which, of course, was completely loose.. The core itself seemed dry and solid.

My advice, without the benefit  of being able to open your pictures, is to go slow. I have attached a picture of the chain plate after removal so you can see what you are dealing with. Access to the chainplate is much less destructive if you reach it through the inner liner rather than from above. By removing small sections of the liner you should be able to find the screw and at the same time determine the condition of the core. If the core is good, you can fasten the chainplate more securely and patch the liner and be done with it. I didn't do that . The second picture shows what the deck looked like after I ground out the old chainplate.

I decided that I didn't want to replace the chainplate as it was originally installed. It seemed to me like a system that would inevitably loosen and probably leak. I filled the cavity I created in the deck with an epoxy mix and then faired and repaired the deck. Doing so created a sizable area of solid epoxy mix through which I installed a ring bolt with shoulders - I can't remember what it was called but attach a picture. I made large washers from composite decking by using a hole saw.The picture shows the composite washer on both sides of the deck but in the end I didn't need the upper one. In this way the bolt was attached in a straight line with the shroud. The bolt went through the solid epoxy fill and was sealed with butyl tape. It seems very secure to me and has no wiggle.

I was intending originally to attach new chainplates to the cabin sides but decided to replace the ports with a single piece of acrylic so there was no place to put the chainplates. In the meantime I inserted a new plywood/epoxy core between the outer skin and liner along the sides of the cabin to provide for increased strength for the chainplates. I now know that wasn't necessary but it can't hurt in my case given that I dramatically increased the size of the port openings. I am telling you all this so you won't be too confused by the pictures

So, if you want to replace the chainplates, you might want to consider this use of shoulder bolts once you know the condition of the deck core.



Graham Stewart
Agile 76



Chainplate.JPG

Chainplates removed 2012.JPG

Lower chainplates with composite spacers.jpg

Filling lower shroud holes.JPG

Filling cabin sides with plywood (2).JPG
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting