The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

BARRY RUEHLEN



Bunk spacing on a boat lift

2024-02-28; 11:30:12 EST

Member Since

2023-06-07

Posts: 42

Thank you .Don, Rick, Peter,Mike,Todd, Chris, Everyone
Don a picture would be very helpful.
 As always, the group comes forth with much information and help. I have read many postings over the past two and a half years of our Rhodes restoration, and bunk placement and bearing areas is still very confusing to me. (our Rhodes came on some half baked old sailboat trailer). I have read that even though the centerboard hangs proud of the keel, it is ok to rest the boat on it, and I've read that it is not ok to rest the boat on it. I have read that the best place to support the boat is close to the keel where the structure is thickest, and the side supports are just for stabilization, and I have read the opposite. In fact I believe that I have read that too much support on the side bunks can cause deformity in the hull. The trailer diagrams that the group just sent me show great dimensions for a side support system, but the actual trailer pictures of a Triad show bottom support close to the keel. and additional side supports.
 I suspect that the best supporting system for a boatlift might be to have the bottom straight bunks close to the keel as in the picture for main support, and then side supports per the CAD drawing with firm to moderate bearing support.
 Sorry for my confusion. We've put a lot of love into this Rhodes restoration, and I don't want to screw this up.
Best,
Barry Ruehlen
S/V Perserverance '87


20231005_102129 (1).jpg

1000001848.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting