The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

peter beckerman



General Boats jib rollerfurler

2024-05-12; 22:22:55 EDT

Member Since

2023-01-29

Posts: 157

Hi All,    At the end of last season I had a somewhat chaotic time getting my boat out of the lake and into storage for the winter.  Several sailing friends helped me out, none of us with any experience with a Rhodes 22.  One of the tasks that I needed to complete was removing the sails from the furlers.  I concentrated on the mainsail, while others removed the Genoa.  In preparation for putting the boat in this year I spent some time the other morning putting the sails back on the furlers.  I understood the mounting system to involve sliding the furler tube into the pocket on the luff of the sail until the grommets line up to screw holes at the head and foot.  Screws are run through the grommet and tightened to the furling tube and Bob's your Uncle.This is exactly how my mainsail installed, but when I got to the Genoa, there was only a screw at the head of the sail.  I could not find one (or evidence of one) at the foot.  Is this correct?  Am I missing something?  Is there a system for keeping the luff taught?  Any insights will be greatly appreciated.
Thanks,   Peter
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting