The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Centerboard control line size/leak

2024-05-19; 10:32:30 EDT

Member Since

2002-08-01

Posts: 1438

Hi Peter,
I may be in the minority; but, I used Dow Corning clear RTV silicone aquarium sealant on the centerboard cap, on both sides of the gasket.  The job is done so infrequently that silicone removal is a mote point.  I’ve only done it once since 1987.   I like the ability of the silicone to conform to scratches or other irregularities plus it can flex with the hull and not leak.  My centerboard cap has thru bolts vs wood screws.  Use the biggest washers that will fit on top and bottom (fender washers if there is room) to spread the load.  I used Nyloc lock nuts.  Torque the bolts in criss cross pattern as if you were torqueing down a cylinder head.  Don’t over torque the the bolts.  When the Silicone RTV is evenly squeezed out all around the joint, that’s tight enough.  Let the silicone cure for 24 hours prior to launching.

Roger Pihlaja
S/V Dynamic Equilibrium
1978  Sanford, MI

Sent from my iPhone

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting