The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Cary Tolbert



stay tightening

2024-06-01; 11:23:15 EDT

Member Since

2012-07-26

Posts: 198

Graham, I have found using stainless steel safety wire (used in aircraft) works well. It comes in small rolls. I cut about 3 inches or 75 mm  and feed it through the hole in the turnbuckle bolts and around the  turnbuckle body then three twists. Then snip off the excess and bend it to the inside. Cheap and holds well but if you need to adjust later , just snipe it off and adjust and re apply. I got the idea from working on naval aircraft's electronic gear many many years ago. Try it, you will like it. Cary Tolbert
S/V Whisper
Claytor Lake, VA

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting