The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Patrick Riley



Honda BF9.9 Oil from carb

2024-06-06; 13:05:56 EDT

Member Since

2009-03-03

Posts: 142

Roger, et. al.,

Finally had a chance to troubleshoot this issue that began as oil dripping from carb intake and smoking some.
I can't find any sign of a breather that might be clogged, everything under the hood is pristine clean.

Oil was definitely overfilled.  I drained out about a pint and it still shows nearly full.  Golden color difficult to see but by rolling the dipstick on a paper towel you could see the top level.  What I drained out also seems to have a viscosity lower than I would expect of pure oil and my wife said it smelled of gas.  So, stuck float is or was a most likely culprit.

I checked compression and got 110 psi on both cylinders. squirted in some oil but could not get it to change.  Seems low but could be my 40 year old tester  and me trying to get a good push seal.  So, my rings are probably not an issue.

So, what next with a sticky float.? I don't want to take the carb apart with my skill level and lack of a clean shop to work in.  It may be fixed already and I was just seeing the after effect of overfilled oil.  I have the motor on a dolly so I can tip it on it side, tap on stuff etc..  I might just try to see if it runs OK before putting in clean oil in case it is still stuck.

Patrick










See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting