The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Patrick Riley



GB tiller-motor link geometry problem

2024-06-06; 13:29:01 EDT

Member Since

2009-03-03

Posts: 142

On this new to me 89 recycled 2012 I have issues with the tiller link.  On my first boat I made a link that worked pretty well.  I recall at higher speed it wanted to just go straight (which was fine).

This one is really squirrelly.  If you start to turn it seems unstable and just wants to go full into a hard turn.  From these pics. at center, turned max port, and max starboard - you can see that the motor is turning much faster than the rudder and it actually stops the rudder from turning as much as I would like to cruise into dock.  It also kind of binds up as the max angle resists turning back from the stops.

On my home built I tried to get the distance from the rudder rotation point to the connecting bar, and the distance from the motor rotation point to the attach point on it to be about the same radius.  In this GB setup, the rudder pin to connection pivot point  is about 16 inches whereas on the motor it is only about 5 inches.  I think this is the problem and I probably need to build an extension to move the attach point on the motor top out further behind it.

Thoughts?

I sort of need this linkage for maneuvering in shallow water where my rudder might get kicked up.  If I leave the motor straight I could have prop. impact.

Patrick

RudderPT.jpg

RudderSB.jpg

RudderCtr.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting