The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Patrick Riley



GB tiller-motor link geometry problem

2024-06-12; 11:00:41 EDT

Member Since

2009-03-03

Posts: 142

Update.  I did try relocating the rudder side link attach pivot point closer to rudder pivot by drilling a new hole.  It improved the ratio a bit but didn't fully resolve the problem.  New configuration began to bump the linkage into swim ladder and still the extreme rotation of the motor head leaves the geometry close to binding from the linkage to motor angle being almost head-on at the end of travel.  Also, I see the wisdom of the left curve of the mount on the tiller side, that allows the linkage arm to swivel around and clamp against the tiller when not in use. That doesn't work if the pivot is centered and closer to the stern.  This one size fits all design apparently just not too good for this tohatsu motor as is. If I get my honda 9.9 working (separate thread) I will use that most likely anyway and it has more distance between pivot and rear of cowling.   If not, I will try extending the linkage point on the motor side further out behind the cowling for the tohatsu..


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting