Here is a drawing of the Traveller End.
I worked on this design with Stan.
Once installed, you need to drill a hole all the way through the SS traveller bar AND through narrow section while it is in place for a 1/4” fast-pin.
Tie the pin to the traveller or the backstay -
That way, you can ease the tension on the backstay, pull the pin and swing the traveller out of the way to one side, or take it off entirely.
It wrks great. The ability to remove the Traveller is a really nice feature. Ric
Dadventure

Richard F. Stott, AIA, LEED AP
ric at stottarchitecture.com
O -631-283-1777
C- 516-965-3164
Traveler End Drawing2.pdf
> On Jun 26, 2024, at 2:32 PM, Peter Nyberg <peter at sunnybeeches.com> wrote:
>> Todd,
>> I measure the distance from the center of the backstay 'cup' for the traveler to the hole at the end of the stay itself as being pretty precisely 15". Additional hardware I've got between the end of the stay and the chainplate adds 3". Hopefully, there's a picture attached.
>> --Peter
>>> [ Sent From rhodes22.net ]
>>> On 2024-06-26, at 12:48:35 EDT, Todd Tavares wrote:
>>>> Peter,
>>>> I am re-doing my backstays. How far up the backstays from the chsinplate pin is
>> the traveller?
>>>> Thanks.
>> Todd T.
>>>>>>> -------------- next part --------------
> A non-text attachment was scrubbed...
> Name: IMG_1523.JPG
> Type: image/jpeg
> Size: 1526292 bytes
> Desc: not available
> URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20240626/78262475/attachment.jpe>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.