The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Continuing compression post saga

2024-06-29; 16:45:10 EDT

Member Since

2002-08-01

Posts: 1438

Hi Matt,

The shoal draft keel has so called internal ballast.  In the picture, you are looking at the top of the internal ballast.  The ballast consists of a slurry of lead shot and Portland cement.  This slurry is poured into the ballast cavity and allowed to cure.  Once cured, this composite ballast material is very strong in compression.  I recommend you run your new compression post down to the top of the ballast and thru bolt it to the wooden stringer.  The thru bolt will prevent the bottom of the compression post from moving around no matter how bad the sailing conditions get.  Make the compression post long enough such that it must be forced into position, not a slip fit.

Do you have rot in the core of your cabin roof?  If yes; then, that must be fixed first.  This fix depends upon the cabin roof being incompressible and rot in the core will invalidate this assumption.

Roger Pihlaja
S/V Dynamic Equilibrium
Sent from my iPhone

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting