The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Ric Stott



Cockpit support/lifting size

2024-07-25; 14:44:39 EDT

Member Since

2013-07-01

Posts: 436

I built one out of Treated 5/4 x 4.  I used a saber saw to cut a 3” deep notch the bottoms so they fit over the transom.
I was 6’ high off the transom.
I drilled a couple of holes at Stern Rail height so I could lash it to the rail. It worked ok, but it was heavy and a roller at the top makes sliding the mast from the bow puppet to the tabernacle kind of difficult.
I got a fee home made oe from a guy in Jersey - it needs to modified also, but it has a roller at the top - makes a huge difference.
Easily fabricated out of 1-1/2” or 2” thick wall  aluminum tube with a 2” PVC pipe over a couple of rubber wheels on a 1/$’ threaded rod drilled thru the top.
Don’t forget cross brace reinforcement.
I used 5” x “ pieces (2 each pipe) of  HDME for the notched  brackets that slip over the transom.  They are thru bolted to the 2” vertical tubes w/ 1/4” x 3-1/2” SS machine screws.
Have fun
Ric
DAdventure

Richard F. Stott, AIA, LEED AP
ric at stottarchitecture.com
O -631-283-1777
C- 516-965-3164



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting