The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Rob Granger



Center Board Lift Line

2013-10-01; 11:02:01 EDT

Member Since

2008-07-27

Posts: 123

Thanks Graham

I think Todd figured it out.  I have an early '73 Rhodes and the board
trunk did not have caps then.  The board is removed from underneath the
boat.  That is how I got mine out so this makes sense.  I had a SS pin
running through the keel that the board pivots on.   I pulled the pin and
the board slipped right out (of the bottom).

I'm saving your dimensions to my hard drive.  I think when I rebuild the
interior, I'm going to set it up so that I can access the board from inside
the boat.  It will make threading the lift line a lot safer and easier.

Thanks again,

the other Rob

I
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting