2013-10-01; 15:31:38 EDT
Member Since
2002-09-10
Posts: 979
Rob, I can not remember if there are three or four blocks on the forward end. I think there are two on the c/b and two on the bottom of that small piece of wood. On my old boat there was not a block but a small crossbar where the line turned up into the hose leading to the cockpit. It would be a challenging task to replace that crossbar. But it can be done. Todd T. -- Sent from my Android phone with mail.com Mail. Please excuse my brevity. Rob Granger <rgranger at sbc.edu> wrote: Thanks Graham I think Todd figured it out. I have an early '73 Rhodes and the board trunk did not have caps then. The board is removed from underneath the boat. That is how I got mine out so this makes sense. I had a SS pin running through the keel that the board pivots on. I pulled the pin and the board slipped right out (of the bottom). I'm saving your dimensions to my hard drive. I think when I rebuild the interior, I'm going to set it up so that I can access the board from inside the boat. It will make threading the lift line a lot safer and easier. Thanks again, the other Rob ISee the original archive post