The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Todd Tavares



Fitting a trailer

2013-10-02; 10:40:10 EDT

Member Since

2002-09-10

Posts: 979

Rob, 

You may not know this but there are dimensioned plans and drawings for the trailer somewhere back in the archives. If you can not find them, I have them on an old computer at home.

Todd T.
-- 
Sent from my Android phone with mail.com Mail. Please excuse my brevity.

Rob Granger <rgranger at sbc.edu> wrote:

I fit my "new-2-me" trailer to the boat yesterday evening. It is a duel
axle trailer that had originally been used on a seahawk-19. I through
bolted a 16' 2"X4"X12" to some tangs I had welded to the frame (one board
on each side). The boards run longitudinally and serve as skids (bunks).
I also welded some rubber (roller) guides for the keel to sit on. I did a
dry fit last night and it was almost right. I need to jack the boat back
up, pull the trailer and make a few minor adjustments .... I'll take some
pics if anyone is interested.

BTW: If you are looking for an inexpensive trailer... I have found that it
is easier to find an inexpensive trailer if you are also willing to buy the
crappy boat sitting on it. Strange market!!! But try shopping for just a
trailer and you will have to drop $1K min. I got the seahawk with trailer
for $500, stripped off all the good hardware (cleats, compass, motor mount,
anchor chocks etc.) and then sold the hull for $100. So... I got this
trailer plus some hardware for $400.


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting