The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Mary Lou Troy



Rhodes22-list Digest, Vol 3339, Issue 1

2013-11-12; 15:41:15 EST

Member Since

2004-01-29

Posts: 1598

Is it possible something was amiss with your lowering technique 
(pop-top slider not raised, sliding hatch not closed, etc.) - that 
something applied excess force as you lowered the mast? If  the mast 
plate had been bolted as you proposed, it would likely have ripped a 
hole in the top of your cabin. Those three screws are meant as a easy 
failure point so you don't seriously damage the boat. The only time 
we've ever had an issue is when we forgot to close the sliding hatch 
and the mast used that as a fulcrum to pry up the step. It was an 
easy fix. We reseated the screws in the holes with some epoxy - I 
think - it was a while ago. No problems since.

Best,
Mary Lou
1991 R22  Fretless
Rock Hall, MD


At 03:17 PM 11/12/2013, you wrote:
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting