2013-11-19; 17:54:06 EST
Member Since
2010-04-26
Posts: 226
The following is courtesy of Jay... Here you go. Note that the straps around the upper and lower bars that hold the double 5/16" blocks are galvanized pipe hangers used along with the line you see as temporary parts of the installation while it is being used and verified to work well. The line is wrapped so that it exits the bottom from an inside roller and outward from the stern. In this way it comes up between the blocks and does not hang up on anything. The final installation, which I will do this winter, will have stainless straps to hang the blocks, a good 5/16" inch marine line and a eye prior to the jam cleat for a stop knot to keep the line from falling loose. The blocks were expensive, but they had to be the best since they are permanent and fully exposed to the water.So far it has worked like a charm. You will also note a small black PVC pipe attached to the upper bar to the right of the upper blocks. The pipe and clamp are parts of an underground watering system sold at Home Depot and very cheap. This prevents the engine mount from tilting inward toward the stern so that the engine can be tilted on its own pivot once it is raised. This was necessary because the forward part of the engine, the fuel line and the throttle handle hit the stern when tilted out of the water on the engine mount pivot. If you keep the engine mount stationary and just tilt the engine, everything clears. Hope this helps. Jay Port Angeles, WA Pics attached Engine Hoist 1 small from Jay.jpg Engine Hoist 2 small from Jay.jpgSee the original archive post