The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

jfn302 at yahoo.com



Hull strengthening

2013-12-20; 14:30:04 EST

Member Since

2013-12-12

Posts: 66

If your foam is like my foam, then it isn't attached.

I cut out the forward v-berth and in the three compartments underneath there was simply blocks of Styrofoam stuffed in there.  Beings that it was about 10 degrees out when I did it, and the boat had been flooded for a while before I got it, some of my Styrofoam blocks weighed in over 10 lbs a piece.
        
The first picture is with the V-berth cut out and only one of the bulkheads still in place.  The plastic bag to the right is full of the old Styrofoam. (the white on the right side of the bag is glare from the sun coming in through a porthole.

https://www.dropbox.com/s/yewcdevyuhv83z8/2013-12-10%2013.47.30.jpg

The second picture shows the interior cleaned out.  I have not removed the "backrest" portion of the interior liner.

https://www.dropbox.com/s/26sbk9sknk3xzrx/2013-12-10%2020.07.58.jpg


Sent from Yahoo! Mail for Windows 8

From: Graham Stewart<gstewart8 at cogeco.ca>
Sent: ?Fri, ?Dec? ?20?, ?2013 at ?1?:?07? ?PM
To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org>
Subject: [Rhodes22-list] Hull strengthening

Lou plans to strengthen his hull and I was considering the same since I havethe interior of my 76 completely stripped out. It seems like the opportunetime to do so if it is worthwhile and if I had some idea of what was needed.It would only be feasible to do the main cabin and possible the forward areaif I remove the foam. I am not sure how the foam is held in place and how Iwould reattach it.Has anyone done this or do they have any technical thoughts about how manylayers of fibreglass should be added? Is it really worth the effort?The reasons I am thinking about this is that I understand that later boatshave a heavier layup and I assume there was a good reason for that andbecause the hull seems overly flexible and has taken a dent where theforward starboard strut of the trailer presses on the hull. I jacked theboat up about 2 years ago and most of the dent has come out, but I thoughtthat some strengthening - perhaps with strengthening ribs of some sort
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting