The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

jfn302 at yahoo.com



Masthead Light

2014-01-12; 11:59:34 EST

Member Since

2013-12-12

Posts: 66

Wiring almost never has a problem, it is very rare that the casing will
chafe through.  If it does, you will notice blown fuses and other electrical
problems throughout the boat because you are getting a short to ground where
it doesn't belong.

The first thing to check is like Theodore says, the bulb, it is the most
fragile piece in the circuit.  And I agree with him, LED is the way to go.
20+ years' worth of life expectancy is worth the few extra dollars you pay
for it.

The next thing to check are the connections.  Both at the top of the mast
where the wire connects to the light and at the bottom of the mast where the
wire connects to the plug that connects the boats wiring with the masts.
Also, be sure to check the wire connections on the boat itself, it doesn't
move as often so it is less likely to have a problem, but never hurts to not
skip a step.

For the wire to light and wire to plug connections you are looking for
cracks in the solder joints, corrosion build up (kind of like you find on
battery terminals)  if there are wire nuts and you can't see the wire to
wire connection inside, then take them off and look for corrosion build up
on the wires.  If there is, clip back to new wire and use a new wire nut to
reconnect the wires.  Then seal the wire nut with electrical tape or they
have a dip-able kind of electrical tape now that works even better.

Finally, examine the plugs, you are looking for broken or missing pins in
the plug, also look for the corrosion we mentioned above.

If all else fails, use a multi-meter to test conductivity from the bottom of
the mast to the light.  If your multi-meter doesn't show any deflection
(change in resistance) then your wire is broken inside the mast.  Use a
piece of string to tie to one end of the wire, pull it through from the
other end.  Once your old wire is out, put the bottom connection on the wire
(much easier when you don't have to work within a few inches of the mast)
and then securely tap the wire to the string and pull it up the channel in
the mast.

I'm fairly certain you will find it is the bulb or a corroded connection,
but hopefully I was detailed enough that if it wasn't either, you can get to
the root of the problem.

Have fun,

James

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting