The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Standing rigging thickness

2014-02-15; 12:28:16 EST

Member Since

2005-04-29

Posts: 816

My boat is a 76 and I have seen no indication of the original rigging
"stretching". I too use a fairly loose rig. I use the gauge mostly to
balance the tension. I also put a pin through the barrel of the turnbuckle
as otherwise I would not be able to tighten it sufficiently by hand.
Basically I want the top side stays to be sufficiently tight to keep the
mast perpendicular to the deck when heeling but still have the lee stays
hang without any tension. The lower stays are only adjusted to straighten
the mast once the long stays are adjusted. 

If you think that your boat may have been deformed by excessive tension, I
wonder if the boat might relax again if left for some time with the mast
removed. I also wonder whether the mast has been left up all year long.
Being in a cold, make that freezing, climate my mast is down at least 6
months of the year so that might be part of the reason that there appears to
be no deformation.

 Would think that adding too much tension can only spell trouble.

Graham 


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting