The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

cjlowe at sssnet.com



centerboard attachment

2014-03-06; 21:58:58 EST

Member Since

2008-02-18

Posts: 319

I have a different take on some of these issues, don't know if I'm right,
probably just a different take. I think I remember someone on the list
saying the pcv pieces slide on each side of the cb pin and act as a
sacrificial bushing , so the stainless steel pivot pin doesn't eat out the
fiberglass in the side and bottom of the grove. Hope I didn't dream that,
because I spent a lot of time making them bushings, mine didn't have them.
  I'm not sure trying to limit the cb's vertical movement is the best
idea. I'm thinking anything you put in the channels has a chance of
falling out and jambing the cb travel. Anything hard screwed in the
channels has a good chance of tearing big holes in the cb trunk and
taking out both sides of the cb cap. If you think fixing the cb cap was
a pain, ask Lou how much fun it is to do repairs inside the centerboard
trunk.
  I'm thinking the best bet is to not anchor/moor in shallow water, don't
motor backward in shallow water, and NEVER EVER splash the boat unless
the cb pendant is cleated with the cb in the UP position. Any other ides
on this are more than welcome.

    Jerry



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting