The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

cjlowe at sssnet.com



Pivot pin bushings

2014-03-07; 20:03:55 EST

Member Since

2008-02-18

Posts: 319

Todd,

  Go to the nabble  page and search garden hose. Should show loose
centerboard after the ads. The one headlined by Billy-Doc has pics. of
the bearings and the hose. The time line is oct. 2010.
  I didn't put the garden hose in on the last rebuild, but it probably
wouldn't hurt.
  I've had the cb out twice since I bought the boat and even the first
time I didn't see any evidence of pivot pin bushings. Like you, I
thought there was a lot of play in the channels. The clearance between
the pin and the cb was ok. I used pvc water pipe, I think it was 3/4".
UHMWPE would probably be better, but I didn't have that in the pile of
junk in the basement. I don't remember the measurements, but I put the
pin in the channels , pushing it to one side and measureing the small
gap between the pin and the outside of the other channel, add the pin
length to the small gap to get max. length of pin and bushing assembly.
Subtract that from the thickness of the centerboard, and devide that by
2 to get the no slop ,self centering, length of each bushing. After
cutting to length, I sanded the outside to fit snugly in the bottom of
the channel, and bored the inside to slide easily onto the pin. My hope
is the bushings will not move in the channel, creating more wear in the
fiberglass, and all the wear will be to the bushings.


    Jerry

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting