The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



companionway trim strips

2014-03-16; 15:17:37 EDT

Member Since

2005-04-29

Posts: 816

Jerry:
The original teak runners on my boat were 40" long x 1.25" wide and .5"
thick.

I just replaced mine but made them from composite decking cut so that the
grain pattern is up. I wanted to make the boat as maintenance free as
possible. I made the new stringers sturdier than the original teak as
composite material is not as strong at teak. I am not sure how that will
hold up - especially with screws driven from below. I might replace the
screws  with bolts. On my boat the hatch slid on strips of Formica that were
broken and needed replacement so I used 1/8 x 1.5 inch aluminium strips. I
have attached pictures of the new rails on my freshly painted top. The
colours in the photo are off - the top is an off white and the rail is a
weathered grey colour. My plan is to use the composite material for the
cockpit trim as well unless it turns out to be problematic. I was not able
to find much on the web that discusses using this material in boats. 

Graham 


Sliding hatch with composite rails December 2013 (2).jpg

Sliding hatch with composite rails December 2013 (3).jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting