The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Ric Stott



Swing keel help

2014-04-30; 15:11:09 EDT

Member Since

2013-07-01

Posts: 438

I just did it on my '84 - which might be different but not sure.
Its not hard, but takes some time.
You can do it while the boat is on the trailer.
Remove the port bench seat
Remove the floor boards,
Unscrew the Center Board (CB) cap - mine has 36 screws.
Remove cap to expose the line and turning blocks.
Remove and clean the rubber gasket then clean the trunk top and cap  
bottom I used M.E.K. or Acetone on the FG, but water and a brush on  
the rubber.
Remove the CB - its heavy, but I did it myself with a line tied to the  
blocks.
The inside of trunk and CB is  probably a mess and needs to be  
cleaned, scraped and painted with bottom paint.
Inspect and or replace the hose (stops) that prevent the CB from  
rising in the channels at the pivot.
Replace line with 1/4 inch no stretch line
Attached are 2 'before' and 3  'after' photos

Ric Stott
s/v Dadventure
Hampton Bays NY

IMG_3636.jpg

IMG_3638.jpg

IMG_3752.jpg

IMG_3754.jpg

IMG_3755.jpg

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting