The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Rob Granger



Swing keel help

2014-05-01; 12:10:48 EDT

Member Since

2008-07-27

Posts: 123

Todd

That is how my keel is.   The pin was not glassed over however.  There were
to diamond shaped SS plates that were screwed into the keel outside. The
plates cover the ends of the SS pin so it does not slide out.  I found the
plates only after removing beacoup layers of bottom paint.  :-)  After
removing the plates, the pin just slides out.  I pushed mine out with a
phillips screwdriver.  The keel plopped out no problems.

The biggest problem I had was locating the two plates in my shed 8 months
later when I put the keel back into the boat....     :-(



Dr. Robert Granger
Department of Chemistry
Sweet Briar College
434-381-6403
rgranger at sbc.edu


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting