2014-05-19; 07:33:06 EDT
Member Since
2014-05-06
Posts: 3821
John, There are several reasons this could happen. First thing is to lubricate the lower bearing with WD-40 or some other marine lubricant. With the bearing moving freely, unfurl the main sail, keeping pressure on both lines. Once fully extended, raise the boom to just above level. Keeping pressure on the outhaul, furl the main. It should roll up nice and tight. If not, perhaps there is an experienced Rhodie near you that can help. Another possible reason for this happening is that the sail itself is not stretched tightly from top of furling tube to bottom. I've seen where the strap at the top has broken. This is an easy fix with the mast down. Rummy In a message dated 5/18/2014 7:59:29 P.M. Eastern Daylight Time, rhodes22-list at rhodes22.org writes: I am having trouble with my mainsail IMF. I cannot get the entire sail to furl. The head furls completely but the tack does not. I have tried to adjust the topping lift but no success. Any suggestions? I remember seeing posts on this some time ago but couldn't find them. John Waldhausen Bainbridge Island Sent from my iPadSee the original archive post