Could you wrap some #14 solid copper wire around it with the end of wire
holding the back of the pin from slipping out of the coil and then snake
it thru the mast slot into the hole in the slider? I said copper wire
because it is easy to bend and common, a coat hanger would work, but
harder to bend.
Jerry Lowe
Hey friends:
>> Today, while I was admiring my new traveler, I experienced trouble with
> my pop top connection to the mast. After raising the pop top, the wire
> ring holding in the locking pin popped off. The pin (eventually, and
> with help from me) worked it's was down to the deck (inside the mast). I
> can't get my big man fingers into the mast slot to reinsert the pin in
> the slider again. I know it will be easily done with the mast lowered
> (which I want to avoid).
>> Does anyone have a similar experience or sage advice on how to get the
> pin back in? (sorry for ending with a preposition, but it was a good
> rhyme) ttfn.
>> Joe Camp
> __________________________________________________
> To subscribe/unsubscribe go to
>http://www.rhodes22.org/mailman/listinfo/rhodes22-list>> For the list Charter and help with using the mailing list and archives go
> to http://www.rhodes22.org/list> __________________________________________________
>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.