2014-06-17; 16:31:21 EDT
Member Since
2014-05-06
Posts: 3821
I have finally put my boat into the lift I built so that I can begin work on the cracks in the keel and would welcome any advice as to how this might be fixed and speculation as to the cause so that I might prevent it from happening again. Picture 1 is of the boat in the lift. This allows me to get under the keel to work in reasonable comfort. The next two pictures show the cracks with the camera under the keel looking up. The centreboard is removed. The cracks run along the edge where the bottom of the keel meets the inside of the centreboard slot. As for the cause, I suspect that some time in the past the keel was damaged leaving a crack that allowed water to enter where it might have froze in the winter doing further damage. On the other hand I would have thought that the water would have drained out before freezing temperatures were reached. There appears to be voids in the keel. The last shot shows were I was drilling out osmosis blisters and went right through the skin into a void. Tapping on the skin often creates a hollow sound suggesting that there are plenty more voids. It seems to me that voids under the skin are a recipe for problems. Drilling holes and pumping in epoxy would not be that difficult for those I find under the outside skin but would be much more difficult for voids under the skin in the centreboard slot - which currently looks intact. I thought I might drill a series of holes through the cabin bottom into the keel and push more epoxy down from above. To find voids I might need to drill a lot of holes. As for the cracks, my current plan, absent any other ideas, is to open the cracks to allow access with a cartridge tip and force thickened epoxy up into the crack. I would then apply layers of cloth and epoxy from about 3" up to the slot down and around the bottom and up 3" on the outside. I have ground out a bevel on the inside to allow for layers of cloth to be added without making the slot too narrow for the centreboard. When all that is done I plan to do the whole bottom - drill out blisters and do the blister prevention program recommended by West System. I don't want to ever do this again so suggestions are welcome. Thanks in advance. Graham Ariel in lift June 16, 2014.jpg Ariel in lift June 17, 2014.jpg Cracks in Keel a.jpg crasks in keel b.jpg voids under keel skin.jpgSee the original archive post