The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Cracks in keel

2014-06-18; 11:24:40 EDT

Member Since

2014-05-06

Posts: 3821

That looked like the swing keel to me... if not then disregard but...

You should take a grinder and grind it down until all lose fiberglass cloth
is gone and only solid fiberglass remains.  then build it back up using
rove and 2-part epoxy resin.  Don't go crazy with the grinder.  You only
want to take off the stuff that is structurally compromised.  You can get
nice smoothed forms during the build up by using plastic sheeting (like you
use for drop cloth painting).   Put 3 or 4 layers off whetted fiberglass
cloth onto the plastic, then form the plastic over the repair area and tape
it in place until the resin sets.  The plastic will peel off and the job
will have a nice smooth finish and shaped the way you want it to be
shaped.  Then sand it a bit...paint and viola

Get Don Casey's book on boat maintenance.  It has a nice write up about
doing this sort of fiberglass work... and I can post some pictures of the
holes in my hull and cracks in my keel that I fixed following his advice.

You can do this in a single afternoon.  The trick is .... don't be scared
to try it.... if you screw it up you can always grind it back off and try
again.  I'm now a complete fiberglass convert.  The stuff is easy to work
with once you get some practice.

The other Rob





Dr. Robert Granger
Department of Chemistry
Sweet Briar College
434-381-6403
rgranger at sbc.edu
????????????????????????


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting