The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Disconnected Rub Rail

2014-06-30; 13:33:04 EDT

Member Since

2014-05-06

Posts: 3821

Don't use screws or glue. Pop rivets.
 
Rummy
 
 
In a message dated 6/30/2014 1:12:56 P.M. Eastern Daylight Time,  
rhodes22-list at rhodes22.org writes:







Hello everyone.
Does anyone have  experience dealing with a detached portion of their rub 
rail?
Approximately  three feet of our rub rail detached from the hull when the 
hull slipped under  the edge of the finger pier during a storm, thus pulling 
the rub rail and its  screws out from the hull.
I tried using a commercial marine glue from Home  Depot. I glued the rub 
rail back and reinserted the screws into their  respective holes, but the 
tension in the rub rail pulled the screws right back  out and the rail remained 
detached. 
The rub rail sits lightly against the  hull at the affected area but 
getting it to glue into the exact proper  position is another matter.
Any advice you may have would be greatly  appreciated.
Thank you.
Frank and Linda George
Rhodies since  2011


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting