The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Drying out the keel cavities

2014-08-02; 11:40:03 EDT

Member Since

2014-05-06

Posts: 3821

For those who are dying to know how the process of drying out the keel is
going, I thought I would post a couple of pictures showing what I am doing. 

I plugged the holes in the sole of the boat and drilled drain holes at the
bottom of the keel and then adjusted the boat fore and aft so that the
bottom of the keel was horizontal. I then made an adapter from plumbing bits
and pieces and shop vac parts that I then inserted into voids on both sides
of the keel like a stethoscope, attached it to the blower side of the vac
and turned it on. The point of the double sided adapter was simply to allow
more air in and to do both sides at the same time. 

Water started dripping from several holes immediately that had not come out
through gravity alone so that is a good sign. I plan to just let it blow
until I think any remaining water has evaporated. The air going in is heated
by the vac to about 110 degrees at the vac and about 90 degrees where it
enters the keel. I will monitor the temperature of the base of the keel in
the hope that as it dries the temperature will raise and then stabilize.

The inside of the boat is about 120 degrees in the sun as I have a heavy
brown tarp covering it. That should dry out any remaining moisture  that
might be in the boat.

I am keeping my fingers crossed - except for the one that my band saw took a
liking to.

Graham 




Drying out keel with shop vac Aug 2014.jpg

Vac Adapter.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting