2014-08-19; 15:31:15 EDT
Member Since
2014-05-06
Posts: 3821
As some of you will remember I was working on the keel and in particular wondering how I might fill voids that I found within it. I have just completed filling the keel, as best I could with polyester resin. I did this by drilling holes along the top of the keel from the outside and anywhere I thought there might be a void. I searched for voids by tapping the surface with a wooden handle of a large screwdriver. This is not a fool-proof method in that after drilling some holes I found no indication of a void. On the other hand I also found some large voids. I also drilled about 6 holes down into the keel through the cabin sole. I injected the resin, thinned slightly with acetone, into the holes in the side of the keel until the void would take no more. I would then cover the hole with masking tape and move up higher and inject the resin there. Once I had injected as much resin as I could through the side holes, I covered them with masking tape and injected more resin down through the holes in the cabin sole. In total I injected 3 gallons and am still not certain I have filled all of the voids. Still, three gallons represents a lot of space particularly if it becomes filled with water and then freezes. If you are anything like me, you have spent countless hours thinking about how to sand the inside slot of the keel. The slot is about 1' deep and varies in width from about .5" at the stern to about 2" in the middle. The best that I could come up with was to attach a round sanding pad with a 20 grit disk to an aluminium strip, reinforced with .5" strip of aluminium angel stock that was in turn attached to a scraper attachment for a reciprocating saw - see attached picture. This works to a point. The problem is that the inside of the slot is not smooth. There are many dips and valleys that the sander cannot reach short of excessive sanding of the surrounding area. The other problem is that it is very difficult to see what is happening and you are unable to feel more than a few inches into the slot with your fingers. For the ends of the slot where the sander it to thick to reach I taped a strip of coarse sandpaper to a length of .5" metal conduit and sanded it manually- see picture attached. If anyone has developed a better way to thoroughly sand or otherwise remove antifouling paint from the slot I would appreciate hearing about it. Since I will be coating the hull with epoxy I would like to so the same with the slot but I worry that remaining antifouling paint in the slot will not allow the epoxy to bond. Finally, I have completed the osmosis and hull repair in that I have dug out any blisters or cracked gelcoat and filled with epoxy and filler. I have attached two photos that show the extent of the repair in some areas. Where the front of the trailer bunk pressed in on the hull I found that the cracks extended through the gelcoat and into the substrate - although not through the substrate as best I could tell. This required grinding out the area and patching it with several layers of cloth before using the filler to fair the area. Later I will reinforce the hull on the inside. In some areas the gelcoat blistering was extensive and did not become visible until the surface was sanded at which point small openings that looked like a rash became visible. By rights I should have removed the gelcoat completely and I worry that the repair will be inadequate. But the prospect of that much grinding and fairing was more than I could contemplate. Given that the boat is 40 years old, I figure that if my repair lasts as long as the original gel coat, I will be happy. I will be 107 by then an probably past my active sailing stage anyway. Graham Sander for end of slot.jpg Bottom stern gelcoat repairs.jpg Home made slot samder.jpg Keel and hull gelcoat removal.jpg Osmosis repair Aug 2014.jpgSee the original archive post